Shotgun Forums banner
1 - 6 of 6 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
I have acquired at no cost a Win 1200 12ga. 2-3/4Cham. Winchoke barrel and manufactured 1974 that was butchered by sawing the barrel and modifying the butt stock. Can anyone tell me if this gun would be worth repairing or should I sell the good parts that are left?
Thanks Gary
 

Attachments

·
Super Moderator
Joined
·
7,451 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
Thanks Bob,
Ran into another problem with the threads in the receiver for the buttstock bolt are messed up. May have to bore and use a threaded insert. I will definatly check out the two websites to see how low I can get the parts.
Gary
 

·
Super Moderator
Joined
·
7,451 Posts
be careful, its alloy. make sure you take your time.
 

·
Registered
Joined
·
5 Posts
Model 1200

I have acquired at no cost a Win 1200 12ga. 2-3/4Cham. Winchoke barrel and manufactured 1974 that was butchered by sawing the barrel and modifying the butt stock. Can anyone tell me if this gun would be worth repairing or should I sell the good parts that are left?
Thanks Gary
There is a lot of parts to rebuild it online. Brownell's is a good one to go to.
 
1 - 6 of 6 Posts
Top