Shotgun Forums banner
1 - 2 of 10 Posts

· Registered
Joined
·
103 Posts
High Brass vs Low Brass

It used to be that High Brass on shotgun shells designated a more powerful shotgun shell; such as, waterfowl and turkey loads with 1 1/4 oz. or heavier shot loads. Low brass designated "field" loads; such as, what one would use for quail, squirrels, rabbits, which had 1 1/8 or less loads (12 gauge).

Such designations no longer hold up. Foreign companies target loads, whether made in loading station they have set up here in the USA or overseas, quite often have high brass; in fact, some companies; such as Fiocchi, Gamebore, Sellier & Bellot, Kemen, ArmUSA, Rio, etc. use high brass quite often to designate higher speed loads (1300 - 1400 fps) with less than 1 1/8 oz. shot. Mostly you find these at the sporting clays or bunker trap (ex-international trap) ranges where lighter 12 gauge loads - 7/8 or 1 oz - at higher speeds are coming popular, but these companies have been entering the hunting market recently. You will see the high brass in field loads, again designating the shot speed in excess of the standard 1200 fps.
 

· Registered
Joined
·
103 Posts
Buckshot at Shooting Ranges

I hope you didn't mean that you shot your #00 buckshot at a skeet, trap, or sporting clays range. By standard, throughout the USA, these ranges limit the maximum shot size to #7 1/2 (USA size) or #7 (Intn'l size). Legal safety zone for these type ranges is 330 - 350 yards (depending upon location), because maximum range for #7 1/2 shot is 290 yards (optimum angle with 25 knot following wind). The maximum range for #00 buckshot without wind is over 500 yards, which could put the shot into roadways or populated areas outside the range's normal safety zone.
 
1 - 2 of 10 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top