Shotgun Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi everyone,
I am new to this forum and am looking to find some guidence in replacing the hammer springs on my skb 500. The lower barrel tends to have light strikes maybe once or twice in 25 shots. I have the kit from skb to replace all the springs but I believe that the lower hammer flat spring may be the culprit. The receiver is clean and the firing pins move freely in their respective spots. All the videos that I have seen on the disassembly of an over and under have shown those with coil springs and not tailored to an skb. Does anyone have any knowledge on the procedure or known videos on this matter? Thanks for any info
one and done
 
1 - 1 of 1 Posts
Top