Shotgun Forums banner

Saiga 12 conversion question.

1319 Views 3 Replies 1 Participant Last post by  ShotgunPro
Is a modified bolt hold open lever needed or will the factory one work?
1 - 4 of 4 Posts
I needed to trim some material off mine to keep it from interfering with the safety. I ended up just buying a new modified one from Carolina Shooters Supply:

BOLT HOLD OPEN LEVER KIT SAIGA 12-MODIFIED
go to saiga forums they can answer anything
Not positive, but I'm pretty sure it's only needed if you use the retaining plate instead of the Sheppard's Crook to hold the pins in (which I did).

Don't waste the money on buying one. It doesn't take anything to cut the notch out of the stock one.
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top