Shotgun Forums banner
1 - 1 of 1 Posts

· Super Moderator
Joined
·
1,457 Posts
The decapping pin should reach the bottom of the hull with no problem if it was set up properly for 3" shells as the position of the spent primer in the collet is the same regardless of the length of the hull. I confirmed this when I put a short kit on my MEC 600Jr. years ago. No adjustments were necessary on decapping or priming or charging, just slight adjustments on the crimp starter and final crimp stations.

Have you tried decapping a 3" hull?
 
1 - 1 of 1 Posts
Top