Shotgun Forums banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
I received a .410 Sizemaster as a gift, and found it was set up for 3” hulls. All of my hulls are 2.5”, so I fitted it with a short kit… only to find the resizing collet and depriving station are a hot mess. Hulls fall all the way through the collet, and the depriming pin doesn’t come close to reaching the bottom of the hull.

I attached a photo… any suggestions?



1 - 1 of 1 Posts