Shotgun Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
12,957 Posts
Discussion Starter · #2 ·
I assume you mean the front? If so, remove the barrel per instructions. Then use a pair of C clip pliers (if universal, set up to squeeze to open), then insert the points into the clip and squeeze. Not going to lie, it "CAN" suck, but atleast when I rotated mine on the M4, that clip was easier than the retarded C clip on the HKS SSQV blow off valve, that dam thing can use a redesign, I sold mine attached to the upper IC pipe to a friend and redesigned a new pipe for the new at the time TIAL BOV.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top